![]() ![]() ![]() Fixed an issue with certain turning profile finishing operations with a face grooving tool where toolpath was not being generated.Fixed an issue with certain turning profile roughing toolpaths where more stock was being left on the model than expected.Fixed an issue with certain turning rest area profile roughing operations where the final pass did not start at z clearance.Added the ability to specify "wear" and "inverse wear" compensation types in turning profile finishing operations.Fixed an issue with certain inside threading toolpaths with "do multiple threads" turned on where threads were created that were crossing each other.Fixed an issue in which full radius grooving tools with negative "Stock to Leave" would result in an error.Fixed an issue in which the wrap radius was not updated when choosing a cylinder and the operation was not accepted.Improved linking in the pocket strategy with enabled rest machining to avoid air cutting ramps.Fixed a stock collision that could occur in 3D adaptive clearing when 'Order by Area' was selected.Fixed several cases where a ramp cutting into the part was generated.Fixed a toolpath calculation failure that could occur in a slot strategy which produced an "Invalid Contours" error.Fixed crashes that could occur in some cases when using the jet, spiral, or trace strategies. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |